92x Suspension and Axles Installation – Time lapse
I installed some new strut mounts and set of USDM STi Pink wagon springs that I found on craigslist. At this time since knew would require an alignment, so I went and purchased a new axle to replace one that was torn since I got the car. This would get all things that would knock the alignment out in one shot to save time. In the process of installing that axle I found that the drivers side was torn again. But the bigger issue I ran into was the inner joint on the axle popped out and was not going back in without removing. but since it was now 3-5 inches longer, the axle would not come out of the hub! I pulled the tie rod, then when separating the ball joint with pickle fork it ripped the crap out of the rubber boot. Domino effect got me good in…
Fix Galaxy S4 i9500 Screen
Goal today is do this. Pry, heat, + patience, and repeat. – – edit – – Success!!
Swap the caps stop the flickering
Samsung SyncMaster 226 BW repair was to stop the flickering when powered on. On some research had found that cheap 3000hr capacitors were used in the psu inside the monitor. To fix just need to dismantle the monitor and replace these components. Puffed up caps = bad news. Used 2x 25v 820uF 1x 25v 330uF